24/7 knowledge networking from feed to food


The points of dust generation in feed processing workshop

The problem of dust in feed processing is the focus of safe production and environmental protection work in feed factories. It is said that feed plants cause different amounts of dust in different processes, such as material conveying, mixing, crushing, screening, packaging and so on. Now let us learn the points of dust generation in feed processing workshop.

Dust generation points in feed processing workshop

1. Feeding inlet:


Most feed plants uses manual feeding to feed raw material into feeding inlet, which is easy to generate a large amount of dust during the process. Therefore, a small vacuum cleaner can be set at each feeding inlet, on the dust cover of feeding inlet. In this way, it can be used as a vacuum for feeding, or as a suction for the base of each feeding elevator, to achieve feeding, dust removal and recycling simultaneously.

2. Hammer mill:


If hammer mill uses mechanical discharging, we can set up a pulse filter at the opposite end of discharge auger, with functions of dust removal and suction. Be careful to lock air at the exit of the conveyer during installation to prevent air leakage. The hammer mill inlet can have a secondary entry to ensure that it has sufficient air volume to pass through the crushing cavity when crushing in different holes, and also solves the problem of clogging of air-lock machine and improves the reliability of the system. This way is also applicable to the process reforming project of current bad suction system of hammer mill.

3. Additives adding


The additives amount is small, so it needs to be added separately in mixer. Due to the fine size of this part of material, it is easy to cause dust although the amount is small. For small feed mills, a dust removal machine can be set up here; for large and medium feed mills, we can set up a vacuum cleaner system or a central dust collection system, which can avoid cross-contamination in the combined wind network, and can make the powder directly return to the mixer to prevent the loss, thereby effectively ensuring the quality of feed.

4. Bin group:


The large and medium feed mills have various high material bins, causing dust when materials are put into the bins, so the negative pressure facilities should be installed. For a combined bin group, it is impossible to have dust removal point for each bin. The point should be determined according to the location, but it should be connected on the upper part of each bin. The dust removal points collected can collect the dust...

Do you already have an account? Log in here

Join the discussion


To read and post comments you need to login or register