24/7 knowledge networking from feed to food


Does the external climate matter?

Does the external climate matter?

Written by Maciej Kolańczyk, Senior Hatchery Specialist

The optimum climate parameters for embryo development – temperature, humidity, and the balance between oxygen supply and carbon dioxide release from the incubator – are the same regardless of the climate zone in which a hatchery operates, up to an altitude of 1,200 metres.

Developing embryos produce CO2 and heat, and moisture evaporates from the eggs. Much of the heat produced is collected by the water-cooling system and the rest is removed, together with the excess moisture and CO2, through ventilation. Used air is replaced by fresh air.

The purpose of ventilation is to provide fresh air and to remove waste products. In addition, fresh air, which is usually drier and cooler than the air inside the incubator, lowers the humidity and absorbs some of the heat produced by the embryos. Ideally, the air exchange is balanced so that the incubator's internal humidifiers, heaters and coolers simply have a corrective function and work only when necessary.

Modern incubators are technically able to fully control their internal microclimate. These systems are designed to maintain or restore the climate quickly after a machine has stopped or started, or if climate parameters deviate from the set points. It is preferable, however, not to have to activate the systems because intensive heating, cooling or humidifying destabilise the uniformity of the internal microclimate. It is a question of balancing the need for fresh air with the need to maintain a stable internal microclimate.

If fresh air were taken directly from outside the building, its parameters would reflect the local conditions: the season and daily fluctuations in temperature and humidity. Even in a moderate climate zone, temperatures can vary by up to 500C throughout the year, and daytime and night time temperatures can fluctuate by 20-300C. Likewise, humidity can vary substantially over 24...

Do you already have an account? Log in here

Join the discussion


To read and post comments you need to login or register